Genshin Impact
Optimized for mobile roots, the PC version offers higher resolution textures and volumetric shadows while keeping minimum specs low. It is light on the CPU but requires a dedicated GPU for stable 1080p/60FPS gameplay.
This game has a built-in FPS cap of 60 FPS
Actual FPS may vary based on RAM speed, background processes, and other system factors
Performance Report
At 1080p, frame rates range from 56 to 71 FPS depending on quality settings. At 1440p, frame rates range from 52 to 67 FPS. At 4K, frame rates range from 37 to 51 FPS.
The GeForce RTX 4090 is 279% above the recommended GPU (GeForce GTX 1060) for Genshin Impact. The Xeon D-2146NT is 11% below minimum CPU requirement.
No major FPS-ceiling mismatch detected. The GeForce RTX 4090 and Xeon D-2146NT stay close in effective frame-generation ceiling across the tested resolutions and quality settings.
This chart answers a simple question: which upgrade is more likely to increase FPS first? In this case, there is no clear winner.
The largest gap still appears at 1080p Low, where the Xeon D-2146NT reaches about 85 FPS, while the GeForce RTX 4090 still has headroom up to roughly 141 FPS.
That means neither part is consistently hitting its ceiling far ahead of the other. Across all tested settings, this pairing is GPU-limited in 0 out of 12 cases, CPU-limited in 4, and balanced in 8.
Overall, this is a balanced combination in this game.
Neither the Xeon D-2146NT nor the GeForce RTX 4090 stands out as the consistent limiter in this game, so the better upgrade depends more on your target settings than on one obvious bottleneck.
This chart shows which upgrade is more likely to unlock more FPS in each tested setting. The lower line represents the part that reaches its limit first. When the CPU and GPU lines stay close together, the system is more balanced. When the gap widens, one component is more clearly holding the other back. Hover any setting to inspect it.
The lower line is the current limiter. The closer the two lines are, the more balanced the CPU and GPU are for this game.
Each line represents an estimated FPS ceiling for one component, rather than live usage alone.
To estimate the CPU ceiling, we pair the Xeon D-2146NT with GeForce RTX 5090, our current GPU anchor. To estimate the GPU ceiling, we pair the GeForce RTX 4090 with Ryzen 9 9950X3D, our current CPU anchor.
The lower line indicates the current limiter, since that component reaches its FPS ceiling first. In most scenarios, that is also the part most likely to deliver the bigger performance uplift if upgraded first.
The percentage shown represents the gap between the two ceilings. In practical terms, it shows how much of the stronger component's potential is left unused because the weaker one becomes the bottleneck first.
See how your processor and graphics card compare against the game official minimum and recommended system specs. The placement of your hardware is calculated using relative synthetic performance scores to help you gauge overall playability.
Your hardware is below minimum requirements. CPU is the limiting factor (11% below minimum). Expect performance issues. Low settings recommended.
-66%vsrecommended
+279%vsrecommended
-11%vsminimum
+1218%vsminimum
The Xeon D-2146NT and GeForce RTX 4090 will struggle to run Genshin Impact at smooth framerates. At 1080p Ultra, you can expect around 56 FPS which is classified as "playable". Consider lowering settings or upgrading your hardware.
Price data is not currently available for this combination. In general, look for setups where the CPU and GPU are balanced - this ensures you're not overspending on one component that the other can't keep up with.
This setup is already well-balanced for Genshin Impact. In the Performance Limiter Analysis, neither side consistently defines the maximum FPS across the tested presets. Across all tested settings, the distribution is 0/12 GPU-limited, 4/12 CPU-limited, and 8/12 balanced. In practice, this pairing behaves as a well-balanced combination in this game. Because of that, upgrading only one component would usually bring smaller gains than improving the overall pairing.
Genshin Impact does not currently support Frame Generation technologies like DLSS 3 or FSR 3. Your performance is based entirely on native rendering. If the game adds support in a future update, newer GPUs will benefit the most.
Genshin Impact requires at minimum a Core i5 (CPU) and GeForce GT 1030 (GPU) with 8 GB RAM and 100 GB storage. For the recommended experience, you need a Core i7 and GeForce GTX 1060 with 16 GB RAM. Your hardware falls below the minimum requirements for this game, which may result in poor performance.
These Genshin Impact FPS results are not arbitrary numbers. They come from calculations informed by thousands of real gaming benchmarks, and the typical accuracy range is around 10% to 15%. That makes them far more useful than generic FPS calculators that simply invent values without a benchmark foundation. Actual in-game performance can still vary with drivers, updates, RAM configuration, cooling, and the exact scene being rendered.
Performance estimates are based on synthetic benchmarks and hardware capabilities.
Results may vary based on drivers, OS, and background processes.
